Gutter Installation Under Drip Edge

If the gutter is lower than the bottom edge of the drip edge install flashing behind the drip edge and over the back edge of the gutter to remove the gap.

Gutter installation under drip edge.

Make sure the outer edge extends over the gutter. How to install a drip edge slip the wide flat flange of the material all the way under the first course of roof shingles as illustrated. Rain gutter installation can be a tricky job and a lot of. If the overlap is too short fix it by placing drip edge under the first row of roof shingles and be sure that the exterior edge is reaching over the gutter.

A gutter apron is installed on the corners above roof decking. Posted by everything gutter on sep 15 2015 in downspouts gutter cleaning gutter guards gutter repair gutter sagging ice dams leaky joints leaky seams new gutters seamless gutters seamless rain gutters comments off on does the gutter go under over or behind a drip edge. The shingles should extend past the top flange of the drip edge. Make sure the drip edge coming from the shingle is bending against the fascia board because when it rains it s going.

A gutter apron is used where shingles are not far enough from the edge of the gutter. If it doesn t pull the drip edge out slightly from under the shingles. One of the reasons is that your shingles may be too short. The water should roll off these shingles and drop straight down into the gutter.

See backflowing gutters for more about gutters installed on top of rather than up under the drip edge lip. For proper water drainage the drip edge on the rakes should always overlap the drip edge on the eaves. The whole purpose is to direct the water into the gutters. While on the other hand a drip edge is installed to the trim and usually hangs directly behind the back of the gutter.

The best practice is to always install the drip edge so that it is inside the gutter. It is put under the shingles of an attic to flow water directly into the gutter. Nail the drip edge to the roof sheathing at roughly 18 24 spacing intervals using roofing nails. It should never be installed outside the gutter i e against the fascia board.

There are two reasons for water getting behind the gutter.