There should be a couple of small knobs on the opener labeled open.
Garage door only opens a foot then stops.
The logic board receives and responds signals to any remote.
Since the door will open with a gentle push the issue will most likely be corrected by applying a bit more power to the opener.
Depending on how old your garage door opener is you may want to replace it if it s old.
The most likely cause for a garage door to only open a few inches when hitting the garage door opener remote control or the garage door opener wall button is.
I can disconnect the trolley from the door then open door manually re connect the trolley to the door.
It will close when activated but will only open a half foot.
If your garage door is closing fully and then reversing to open again then it may be due to a problem with the close limit switch.
A garage door that only opens halfway becomes a nuisance for many reasons.
My garage door opener craftsman only allows door to open a half foot then stops.
You might need to consider replacing it if your door is not working properly or you may purchase a new opener.
Quite often the cause of your door s malfunction is an improperly set garage door limit.
Then when activated the door will close as advertised but will only open part way.
If the door is working properly it should be easy to lift by hand.
If your garage door opens and suddenly stops it might be because of your logic board.
Presing the remote button again.
In order to fix this you ll want to make small changes to the close limit setting until the door opener knows to stop once the door has reached the floor.
Try to operate the garage door manually this helps you determine if the problem is related to the door or the motor.
Call 630 271 9343 serving dupage co.
A faulty logic board could also be a reason your garage door opens then stops.
I bought this house 1 5 years ago with attached garage garage door opener when it gets very cold out the remote will only open the door about 1 foot then stop.
This requires a simple turn with.
The garage door can be operated manually by disconnecting the garage door opener from the door using the red pull cord.